WHOA, HTTP over #Reticulum with RServer and MeshBrowser. Format is rweb://destination_address. Though I don't have direct links to the GitHub yet. I think they might be in the video description though.

Well, there is an experimental #Reticulum #RNode firmware for the Heltec MeshPocket. So far it at least boots, though I wasn't able to connect it to my app #Columba.

GitHub

Added support for Heltec Mesh Pocket by TheBeadster · Pull Request #87 · liberatedsystems/RNode_Firmware_CE

I have used these ID's #define PRODUCT_HELTEC_MESHP 0xD2 // Heltec Mesh Node MeshPocket with a T114 #define BOARD_HELTEC_MESHP ...

I wonder if somebody like #CloakedWireless could offer fixed wireless home internet service. I am personally not aware of any ISP that you can pay with #Monero. It seems like Starlink or Amazon LEO would be good candidates for this because of the fact that they operate in countries that don't have good banking systems, but apparently they don't either. Also, being able to mine your bill just kind of makes sense.

Scenario: I have an automation called John's AC. John's AC has four separate triggers. Max, minimum lower temperature, lower temperature, upper temperature, and max upper temperature. If the room temperature is below max lower temperature or lower temperature and it warms up to either of those two triggers, the automation gets triggered and creates a log event. Question: Is there some way to make triggers enable and disable other triggers in their conditions? What I was thinking about doing is having upper temperature and max upper temperature be the only two active triggers. If either was hit, John's AC would then turn on and the triggers for lower temperature and max lower temperature would be enabled until one of those two triggers was hit, at which point John's AC would turn off, and those two triggers would be disabled. until upper temperature got hit again. Admittedly, it's a lot of work, just to avoid a couple of log messages, but just for shits and giggles, I wonder if it's possible #HomeAssistant

Anyone else had a problem with meshcore-open where after having it connected to your node for several days, the app just will no longer find the device at all? I have tried * restarting the mesh device * restarting the phone * turning Bluetooth off and back on * forgetting the mesh device from Bluetooth settings The only thing I found that did work was factory resetting the node.

GitHub

[BUG]: Node cannot be found after several days · Issue #331 · zjs81/meshcore-open

I'm not exactly sure what is causing the problem, but I will point it out so that you know that it might be an issue, and maybe others might be abl...

#Meshcore

I registered my very first passkey today using KeePass.

Hmmm, turns out I can't install #I2P alongside #HomeAssistant. It would kind of make sense for I2P to be on that box since it's always on anyway.