Here’s the parts list for this #meshtastic build.
RAK Wisblock Meshtastic Starter Kit:
6dBi low-profile antenna:
Antenna cable:
Waterproof junction box:
USB-C mount:
5w USB-C solar panel
3.7v Li-ion battery pack:
Important Note about this battery pack: the positive and negative leads were reversed when I compared it to the plug on the Wisblock board. Use a needle to lift the tiny plastic clips at the end of the wire holding the metal leads in place. Then you can pull them out (don’t force it) and slide them back each into the other side. BE SURE TO VERIFY the polarity with the Wisblock plug. You can damage the board if you put it in backwards!
Wisblock mounting bracket:
2” metal washer with 5/8” hole
Rubber washer with 5/8” hole
Zip-ties, screws, etc.
A step-bit like this one is SUPER handy to drill the 5/8” holes in the junction box. I also had to use it to increase the size of the hole in the metal washer since it came with only a 1/2” hole.
View quoted note →
Rokland
RAKwireless WisBlock Meshtastic Starter Kit US915 SKU 116016
Meshtastic® is an off-grid messaging system using inexpensive hardware to create your personal mesh. Radios forward messages to the next node to d...
Rokland
6 dBi Low Profile N-Female Omni Outdoor 915 MHz Antenna for Helium RAK
Rokland introduces our 6 dBi 915 MHz low profile 21.6" fiberglass antenna with an N-female connector and U-bolt bracket mount. This is certified an...
Rokland
UFL(IPEX/IPX) Mini PCI to N-MALE Pigtail Cable Extension RG178 - RGIPX
IPEX to N Male Cable Using RG178 Coax Length 8 inches /20 cm Impedance: 50 Ohm, Metal: copper Simple connection and disconnection Applications incl...
Amazon.com
Amazon.com
Amazon.com
Amazon.com
Amazon.com
Amazon.com
Amazon.com
Amazon.com
RAK19007 WisBlock Base Board Mount by nano | Download free STL model | Printables.com
Amazon.com: Step Drill Bit
Amazon.com: step drill bit
