Here’s my latest 3d print - a hanger for my headphones on the back of my desk. It keeps them tucked out of sight but I can still lean forward and grab them when I need to.
I think I need to adjust the design to make the headphones sit a little higher because right now the rubber piece where the cord comes out of the bottom is bending as the weight of the headphones presses down on them. I have been getting by in TinkerCad but it might be time for me to learn how to use a real 3D modeling tool. Any recommendations on resources/videos for that?
I think I need to adjust the design to make the headphones sit a little higher because right now the rubber piece where the cord comes out of the bottom is bending as the weight of the headphones presses down on them. I have been getting by in TinkerCad but it might be time for me to learn how to use a real 3D modeling tool. Any recommendations on resources/videos for that?