Finally, Lilygo T-Deck is on it's way 🎉
Still looking for a case design to print and a suitable antenna 868MHz... Any tips?
#meshtastic #asknostr
Login to reply
Replies (10)
its*
For unidirectional, I guess a rubber duck style copper wind should suffice?!?
any results on case?
I'm gonna print the one by Alley Cat.
Got an nice 5dbi antenna so should get some propper reach.
just waiting for some parts for the printer, prob gonna be able to print somewhere next week.
https://www.printables.com/model/741124-lilygo-t-deck-case
i had come to the same conclusion. i've had all the parts and just needed this print. nice to have a printer to sort out some of the sizing issues discussed. good luck.
Nice looking good🤙 Did you +1%? And what battery did you choose?
After etsy suspended my account to shake me down for a serious amount of personal info, i resorted to finding some one local with a printer. i need to learn more about the craft, but as i understand there was no resize using pla+ for two copies for standard front and back. the 8000mAh would fit, but the battery shown is the 5000mAh. i damaged the power switch popping the board back out of the case. still scratching head over how the speaker attaches to the side.
Prob whent a bit overboard 😂 
nice!