New heltec v3 case & holster are siiiick!
That neon green screams #cyberpunk, the purple reminds me of the joker, and an unstoppable mesh network oozes #cypherpunk
It's also very functional. The holster really locks the device in place. There's no risk of it falling out just by moving around.
I don't think I could have possibly done any better with this.
I re-used parts I already had (except having to buy a $10 battery because the ones I have are all too big), but if I started with nothing more than heat shrink tubing, a soldering iron and some solder, it'd cost about $68 for the parts (but only around $42 without the holster).
With the amount of cleanup I had to do on the 3D-print to get the buttons moving smoothly and the board to snap into place, I have no interest in making these for other people. 😆 Y'all can DIY. 💪
#meshtastic #mesh #radio #3Dprinting
It's also very functional. The holster really locks the device in place. There's no risk of it falling out just by moving around.
I don't think I could have possibly done any better with this.
I re-used parts I already had (except having to buy a $10 battery because the ones I have are all too big), but if I started with nothing more than heat shrink tubing, a soldering iron and some solder, it'd cost about $68 for the parts (but only around $42 without the holster).
With the amount of cleanup I had to do on the 3D-print to get the buttons moving smoothly and the board to snap into place, I have no interest in making these for other people. 😆 Y'all can DIY. 💪
#meshtastic #mesh #radio #3Dprinting
